Holding the 'C' key while hovering over a screen layer, picks up the closest magnet to start drawing a connector.
Articles in this section
- What is Overflow?
- What do I need to install Overflow?
- How much does Overflow cost?
- What is the Overflow Sketch plugin?
- How can I easily pick up a screen layer to start drawing a connector?
- How can I show the device skin on a screen?
- How do I update my Overflow screens with new designs?
- How can I print my flow diagram to put up on a wall?
- How can I make a screen scrollable in the rapid prototype?
- Can I experience/ test my user flow on a mobile device?